Refueling; Starting The Stove Starting The Stove; Building A Fire Bu Ilding A Fire Ilding A Fire; Early Signs Of An Overfired Stove Early Signs Of An Overfired Stove - Enerzone Euromax Owner's Manual

If your stove runs out of pellets, the fire goes out and the auger motor and blowers will run until the stove cools down. This
will take a few minutes. After the stove's components stop running, a warning message "NO FUEL" will appear on the LCD
display.
To restart the stove, press the "RESET" button, refill the hopper, and press the
button.
2.16. 2.16. 2.16. 2.16.

REFUELING

REFUELING REFUELING REFUELING
We recommend that you not let the hopper go completely empty. Upon reloading, if the hopper lid stays for open more
than 3 minutes, a warning code ''HOPPER LID OPEN'' will appear on the LCD display. To restart, press the "RESET" button, and
then press the round "ON/OFF" icon on the main status page to start the unit.
KEEP HOPPER LID CLOSED AT ALL TIMES EXCEPT WHEN REFILLING. THE HOPPER MAY BE FILLED WHILE THE FURNACE KEEP HOPPER LID CLOSED AT ALL TIMES EXCEPT WHEN REFILLING. THE HOPPER MAY BE FILLED WHILE THE FURNACE KEEP HOPPER LID CLOSED AT ALL TIMES EXCEPT WHEN REFILLING. THE HOPPER MAY BE FILLED WHILE THE FURNACE KEEP HOPPER LID CLOSED AT ALL TIMES EXCEPT WHEN REFILLING. THE HOPPER MAY BE FILLED WHILE THE FURNACE IS OPERATING.
DO NOT OVERFILL HOPPER. DO NOT OVERFILL HOPPER. DO NOT OVERFILL HOPPER. DO NOT OVERFILL HOPPER.
2.17. 2.17. 2.17. 2.17. STARTING THE STOVE STARTING THE STOVE STARTING THE STOVE STARTING THE STOVE
Before to start your stove, fill hopper and clean burn pot. Once the hopper is full of pellets, the auger is filled, and the
firebox door is closed, you can start the stove. In order to start the stove, select the desired mode (manual or
thermostatic) then simply press the round "on/off" icon on the main status page.
If fire doesn't start in 35 minutes, a warning code
section for more details.
2.18. 2.18. BUILDING A BUILDING A FIRE FIRE
2.18. 2.18. BUILDING A BUILDING A FIRE FIRE
Never use a grate or other means of supporting the fuel. Use only the Enerzone Euromax approved burn pot.
NOTE: During the first few fires, your stove will emit an odor and a small amount of fumes as the high temperature paint NOTE: NOTE: NOTE:
cures or becomes seasoned to the metal. Maintaining smaller fires will minimize this. Avoid placing items on stovetop
during this period because paint could be affected. Make sure the room is well-ventilated. Open windows. Odors and
fumes released during this process are unpl fumes released during this process are unpl fumes released during this process are unpleasant but they are not toxic. fumes released during this process are unpl
2.19. 2.19. 2.19. 2.19. EARLY SIGNS OF AN OVERFIRED STOVE EARLY SIGNS OF AN OVERFIRED STOVE EARLY SIGNS OF AN OVERFIRED STOVE EARLY SIGNS OF AN OVERFIRED STOVE
If you see a lazy, very high orange flame inside the firebox, it may be a sign that your stove is overfired and getting too hot.
Under normal conditions, the flame should be about 12 inches high and it should be lively. It should have a bright, yellow
color. Too much restriction in the venting system and a blocked heat exchanger are the primary causes of an overfired
stove. If the stove becomes too hot, it will activate the thermistor located on the exhaust box beside the exhaust blower. If
this occurs, a "UNIT OVERHEAT" code will appear on the LCD display. If you obtain a "UNIT OVERHEAT" code, it is a sign that
your stove is getting dangerously hot. You need to clean the heat exchanger and verify the venting system. If you get a
"UNIT OVERHEAT" code again, call your dealer.
2.20. 2.20. 2.20. 2.20. SHUT DOWN PROCEDURE SHUT DOWN PROCEDURE SHUT DOWN PROCEDURE SHUT DOWN PROCEDURE
Turning your stove off is a matter of pressing the round "ON/OFF" icon on the main status page. The little flame at the
center of the icon will disappear when the stove is turned off. The blowers will continue to operate while the stove is
cooling down.
2.21. 2.21.

OPERATING SAFETY PRECAUTIONS

OPERATING SAFETY PRECAUTIONS
2.21. 2.21. OPERATING SAFETY PRECAUTIONS OPERATING SAFETY PRECAUTIONS
easant but they are not toxic. easant but they are not toxic. easant but they are not toxic.
button followed by FEED AND START
IS OPERATING. IS OPERATING. IS OPERATING.
will appear. Refer to troubleshooting
Odors and Odors and Odors and