Pre; Pre Pre Start; Up Check; Filling - Enerzone Euromax Owner's Manual

Pellet stove
Hide thumbs Also See for Euromax:
Table of Contents

Advertisement

According to your preferences, you can also be able to set the pilot lag time to 30, 45 or 60 minutes. In order to change the
pilot lag time, refer to the operation tree at the beginning of this section.
NOTE: When in thermostatic mode:
NOTE:
NOTE:
NOTE:
You should not operate the manual control or play with the temperature setting.
YOUR THERMOSTAT SHOULD BE INSTALLED BY AN AUTHORIZED DEALER OR SERVICE PERSON.
The size of wires will vary with the distance:
The size of wires will vary with the distance:
The size of wires will vary with the distance:
The size of wires will vary with the distance:
2.13.
2.13.

PRE

PRE- - - - START
START- - - - UP

UP CHECK

CHECK
2.13.
2.13.
PRE
PRE
START
START
UP UP
CHECK
CHECK
Remove burn pot, making sure it is clean and none of the air holes are plugged. Clean the firebox, and then reinstall burn
pot. Clean door glass if necessary (a dry cloth or paper towel is usually sufficient). Never use abrasive cleaners on the
glass or door. Check fuel in the hopper, and refill if necessary. Make sure that the fresh air inlet damper is open.
2.14.
2.14.
2.14.
2.14.
FILLING- - - - UP THE AUGER

FILLING

FILLING
FILLING

UP THE AUGER

UP THE AUGER
UP THE AUGER
When the stove runs out of pellets, it empties the auger housing. In order to start the stove again, you need to fill the
auger to bring pellets to the burn pot for ignition. This process takes approximately 1 minute and a function has been
programmed on the LCD interface. In order to fill the auger, push the auger button. When that button is pressed, a 3 option
window appear:
Auger button options
The FEED AND START button is use when you start the stove after the hopper run out of pellet. The auger will run
during 1 minute the stove will start automatically an ignition sequence.
The PURGE SCREW button is use to empty the auger at the end of the season, the auger will run during 4
minutes.
The ADD PELLETS button is use to add more pellet in the burn pot, the auger will run for 20 seconds.
2.15.
2.15.
2.15.
2.15.
IF YOUR STOVE RUNS OUT OF PELLETS
IF YOUR STOVE RUNS OUT OF PELLETS
IF YOUR STOVE RUNS OUT OF PELLETS
IF YOUR STOVE RUNS OUT OF PELLETS
DISTANCE
DISTANCE
DISTANCE
DISTANCE
20 ft
30 ft
40 ft
50 ft
Figure 24
DIAMETER
DIAMETER
DIAMETER
DIAMETER
18GA
16GA
14GA
12GA
Make sure that the fresh air inlet damper is open.
Make sure that the fresh air inlet damper is open.
Make sure that the fresh air inlet damper is open.
FEED AND START
PURGE SCREW
ADD PELLETS

Advertisement

Table of Contents
loading

Table of Contents