Choosing The Heat Setting Choosing The Heat Setting; Choosing The Pilot Lag Time Choosing The Pilot Lag Time; Choosing The Convection Blower Speed; Choosing Manual Or Thermostatic Mode - Enerzone Euromax Owner's Manual

Pellet stove

Hide thumbs Also See for Euromax:

Table of Contents

2.8.

CHOOSING THE HEAT SETTING

2.8.

CHOOSING THE HEAT SETTING

Your Euromax has an input starting at 10,500 BTU which can reach up to 70,000 BTU. There are six heat levels to choose

from. In order to change the heat level, pressing on the desired heat level. The flame icon will change the color of the

flame to red to show its activation.

2.9.

CHOOSING THE PILOT LAG TIME

It is possible to change the setting of your unit such that if the thermostat does not call for heat after 45 minutes, the unit

will remain at the lowest heat setting (#1) without shutting down (this is the PILOT ON mode). The stove will remain at the

lowest heat level until the thermostat calls for heat again. It is also possible that the unit shuts down as soon as the

thermostat stops calling for heat. This mode is called "PILOT OFF". Also you can set the lag time to 30, 45 or 60 minutes. If

you prefer that your unit runs following one of these logics, you need to change the setting to PILOT ON or PILOT OFF. In

order to change the pilot lag time, refer to the operation tree at the beginning of this section.

2.10.

When you press the convection blower speed button, a screen appears with a cursor to adjust the fan speed as desired;

2.11.

In the manual mode, your stove will run continuously at the feed rate selected until the stove runs out of pellets.

When set in thermostatic mode, the stove will automatically run at the heat level selected until the set room temperature

is reached. When that occurs, the stove will switch to heat setting #1 (lowest), which is the pilot mode, until the

thermostat calls for heat again. When the thermostat calls for heat again, the stove will increase its feed rate to match

the heat setting selected, refer to the operation tree at the beginning of this section.

Figure 21

Fan Speed Control

Table of Contents