Electrical Diagram; Electrical Diagram Electrical Diagram - Enerzone Euromax Owner's Manual

5. Combustion blower is not working properly.
6. Bad pellets
(Applies to "GLASS SOOTS UP AT A VERY FAST RATE" Only)
• The control board does not display any information.
The control board does not display any information. The control board does not display any information. The control board does not display any information.
Possible Causes: Possible Causes: Possible Causes: Possible Causes:
1. A fuse on the control board has blown.
Possibles Possibles Causes Causes: : : :
Possibles Possibles Causes Causes
Warning generated by a power failure while the stove was
running.
SMOKE SMELL OR SOOT BUILD- - - - UP SMOKE SMELL OR SOOT BUILD SMOKE SMELL OR SOOT BUILD SMOKE SMELL OR SOOT BUILD UP UP UP
Because it is a pellet-burning device, your Euromax may emit a faint wood-burning odor. If this increases beyond normal,
or if you notice an unusual soot build-up on walls or furniture, check your exhaust system carefully for leaks. All joints
should be properly sealed. Also clean your stove, following instructions in "MAINTENANCE
your dealer.
5. 5. 5. 5.

ELECTRICAL DIAGRAM

ELECTRICAL DIAGRAM ELECTRICAL DIAGRAM ELECTRICAL DIAGRAM
Check if the blower is still working (separately – bypassing the control board). Make
sure that there is not any obstruction in the fresh air kit and into the air intake tube.
The brand of pellets or the batch of pellets that are being used may be of poor quality.
If possible, try a different brand of pellets. You might also want to try a brand that is
made from a different type of wood (softwood vs. hardwood). Different woods have
different characteristics when being burned. Your pellets may also be too humid.
Make sure you store your fuel properly, in a dry ventilated area.
Possible Remedies : Possible Remedies : Possible Remedies : Possible Remedies :
Remove the control board. Check if the F7 fuse on the back of it appears to be bad.
Replace it with a 7.5 Amp 250 Volt fuse. Plug the stove back in and try to run the unit.
Possibles Solutions: : : : Possibles Solutions
Possibles Solutions Possibles Solutions
The stove will restart on the initial setting once it cools off.
Note: For a short power failure (less than 5 seconds), the stove will continue to
function at the selected speed.
MAINTENANCE". If problem persists, contact MAINTENANCE MAINTENANCE