Operating The Stove Using A Thermostat; Thermostat Installation - Enerzone Euromax Owner's Manual

2.12. 2.12.

OPERATING THE STOVE USING A THERMOSTAT

OPERATING THE STOVE USING A THERMOSTAT
2.12. 2.12. OPERATING THE STOVE USING A THERMOSTAT OPERATING THE STOVE USING A THERMOSTAT
A thermostat may help you maintain a constant house
temperature automatically. A millivolt thermostat is
required. A fixed wall mount or hand held model can be
used. The control panel can be set up three ways to
operate your stove in thermostatic mode.
2.12.1. 2.12.1. Th Th Th Thermostat Installation ermostat Installation
2.12.1. 2.12.1. ermostat Installation ermostat Installation
•
Unplug the stove from the power outlet.
•
Connect two thermostat wires to the terminal block
located on the lower right side of the back of the stove.
To do so, loosen the two screws and insert the wires in
the terminals. Tighten the two screws. (See figure 22)
•
If you are using a wireless wall thermostat or a hand held thermostatic remote control, you can locate the receiver
behind the stove's back panel, on the right end side, just below the terminal block. Most receivers are already
equipped with quick-connect terminals. Simply unplug the PC board wires connected to the back of the terminal
block and connect them directly with the receiver's terminals. Location of the thermostat is very important to obtain
the best comfort and efficiency from your EUROMAX. The thermostat should be mounted 50 inches from the floor on a
wall located 15 to 20 feet from the stove. You should avoid an installation directly in front of the stove to avoid
cycling.(See figure 23)
N.B.: N.B.: N.B.: N.B.: It is possible to change the setting of your unit such that if the thermostat does not call for heat after 45 minutes(lag
time), the unit will remain at the lowest heat level (#1) but will not shut down (this is the PILOT ON mode). The stove will
remain at the lowest heat level until the thermostat calls for heat again. In the other way, it is also possible that the unit
shuts down as soon as the thermostat stops calling for heat. This mode is called "PILOT OFF". If you prefer that your unit
runs following one of these logics PILOT ON or PILOT OFF, you need to change the setting to ALWAYS ON or PILOT OFF.
Figure 23
Thermostat Location
FIGURE 22
Rear view