Table of Contents
Advertisement
Quick Links
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
These instructions are supplementary to the Installation and
Operating Instructions supplied with the fi replace and should be
kept together. Refer to the Installation and Operating Instructions
for proper gas supply, safety requirements and operating
instructions
011110-8
TC36
COUNTRY HOME
BURNER KIT
INSTRUCTIONS
(NATURAL GAS ONLY)
PART#
TC36.NG02CN
For TC36 & 36 Arch
Series C
TC36.NG02CN
5056.42702
Advertisement
Table of Contents
Related Manuals for Town & Country Fireplaces TC36.NG02CN
Summary of Contents for Town & Country Fireplaces TC36.NG02CN
- Page 1 Operating Instructions supplied with the fi replace and should be kept together. Refer to the Installation and Operating Instructions for proper gas supply, safety requirements and operating instructions TC36 COUNTRY HOME BURNER KIT INSTRUCTIONS (NATURAL GAS ONLY) PART# TC36.NG02CN For TC36 & 36 Arch Series C 011110-8 TC36.NG02CN 5056.42702...
-
Page 2: Contents Of Package
2. Slide the burner back to engage the screws in the small part of the keyhole slot and tighten screws. (Fig. #1b) 3. Remove access cover from side of fi rebox(Fig. #1c) Fig. # 1 Fig. # 1b SCREWS Fig. # 1c TC36.NG02CN 210411-16... - Page 3 Red end to the connector marked by the red dot, white end to the connector marked 2 SCREWS by the white dot Fig.#2 & Fig.#3 BULKHEAD PLATE Fig. # 3 WHITE END TO RED END TO MODULE WHITE DOT RED DOT TC36.NG02CN 210411-16...
- Page 4 PILOT SUPPLY TUBE MAIN GAS SUPPLY TUBE 6. Position the slots of the grate securing Fig. # 4 brackets over the holes in the fl oor shield and secure with the two screws (Fig. # 4). TC36.NG02CN 210411-16...
-
Page 5: Ember Material Placement
Note: Ember material placement and amount will affect fl ame appearance. More ember material results in lower fl ame height. Add or remove as needed until desired fl ame affect. GLOWING EMBERS TC36.NG02CN 210411-16... -
Page 6: Log Placement
The three main logs have holes and / or pins. Engage each pin in the corresponding holes. The four smaller logs do not have holes or pins. They rest in position. Locate as per the diagrams (fi g. # 6-13). Fig #7 TC36.NG02CN 210411-16... - Page 7 Fig #8 Fig #9 TC36.NG02CN 210411-16...
- Page 8 Fig #10 Fig #11 TC36.NG02CN 210411-16...
- Page 9 Fig #12 Fig #13 Note: Improper placement of logs will cause sooting on internal parts and glass. The logs may need to be repositioned slightly to avoid excessive fl ame impingement. TC36.NG02CN 210411-16...
-
Page 10: Gas Pressure Check
Fig #15 Fig #16 SUPPLY PRESSURE MANIFOLD PRESSURE Correct gas pressure requirement: Supply Pressure Natural Gas (For purpose of input adjustment) Minimum 5.0" WC Maximum 13.9" WC Manifold Pressure Maximum 3.8" WC Minimum 2.1" WC TC36.NG02CN 210411-16... -
Page 11: Burner Flame Adjustment
3. Remove the air defl ector from the log grate. 4. Loosen the screw in the Primary Air Shutter. PRIMARY AIR SHUTTER (Shown in closed position) 5. Rotate the shutter to increase or decrease the amount of primary air. 6. Re assemble in reverse order. TC36.NG02CN 210411-16... -
Page 12: Replacement Parts
(WHEN ORDERING, INCLUDE PART NUMBER WITH DESCRIPTION) ITEM ..DESCRIPTION ..........PART NO. ITEM ..DESCRIPTION ..........PART NO. #4..PILOT ASSEMBLY ......TCRP.5005025 #1..COUNTRY HOME BURNER ASSY ..TC36.NG02CN #5..MAIN SUPPLY TUBE ......5019.223 #2..7 PCS LOG SET ......... 5098.746108 #6..PILOT TUBE ........5019.225 #3.. - Page 13 TC36.NG02CN 210411-16...
- Page 14 TC36.NG02CN 210411-16...
- Page 15 TC36.NG02CN 210411-16...
- Page 16 TECHNICAL SUPPORT: 1-250-748-1184 townandcountryfi replaces.net 2975 Allenby Rd., Duncan, BC V9L 6V8 Printed in Canada...
Need help?
Do you have a question about the TC36.NG02CN and is the answer not in the manual?
Questions and answers