Steel City 35990CG User Manual page 20

FENCE & RAIL
ASSEMBLY PROCEDURES
WARNING
!
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
1. Fasten the front rail to the table top using four
5/16-18x5/8mm Pan Head Soc Head Screws (A)
SEE FIG.13
Fig. 13
A
2. Fasten both rear rails to the table using four
5/16-18x5/8mm Hex Head Screws (B) with M8 Flat
Washer and M8 Lock Washer.
SEE FIG.14
Fig. 14
3. Connect the right guide tube (long) and left guide
tube (short) with cap (D), and place them on the front
rail. SEE FIG. 15
4. The guide tube must be fasten by eight M6X16mm
Allen Pan Head screws (C) with M6 Flat Washer
and M6 Lock Washer. SEE FIG.15
B
Fig. 15
5. Place the Fence Body (E) on the table top and against
the blade to make sure that if the "zero" scale on the
cursor (F) is align with the "zero" scale of the right/left
scale label stuck on the guide tube.
6. Loosen the pan head screw (G) and move the cursor
(F) till the zero scale aligns with the zero scale on the
right/left scale. SEE FIG.16
Fig. 16
7. Install switch assembly with two M6x16mm Allen Pan
Head Screws, Washers and Lock Washers (H).
SEE FIG.17
Fig. 17
20
D C
G
H
G
F
E