Table of Contents
Advertisement
Skyroute CL3050 Universal Wireless Communicator
Section 2: Quick Start
2.1 Installation
1
Determine The Operating mode required
The operating mode (modes 1, 2, or 3) will determine how the unit is to be wired
up. Refer to section 6, Programming Descriptions, section [10] for available
options and for programming defaults. See section 4, Power up Sequence for
selection of Operating and Programming modes.
NOTE: For UL Installations, use only mode 2 or 3.
2
Determine the Mounting Location
Select a mounting location in a dry, protected area. The mounting location
should be positioned so that it is at least 30 cm. away from physical contact with
any person.
NOTE: Do Not exceed the following recommendations for wire run distances
•
Keybus and zone wiring should be run using minimum 22 gauge quad
(0.5mm). Two pair twisted is preferred.
•
a keypad, PC5108, or zone wiring can not exceed 1,000'/305m (in wire
length) from the Skyroute CL3050.
•
Shielded wire is not necessary unless wires are run in an area that may present
excessive RF noise or interference.
•
Refer to section 6, Programming Descriptions, section [10] for zone wir-
ing details.
NOTE: Generally, the higher the location and the closer that the Skyroute CL3050
is to an outside wall, the better the signal strength will be.
3
Checking Signal Strength
•
Remove front cover
•
Connect Battery to the RED and BLK flying leads.
•
Connect AC Power source or 12 V
•
Allow unit to power up
NOTE: The unit does not need to be enrolled with Connect 24 to check signal
strength.
•
When the green LED stops flashing, press and release the enroll button.
•
Ensure that Radio Signal Strength Indication (RSSI) is greater than the mini-
mum acceptable level as indicated below. If the signal level is not accept-
able, reposition and retest the Skyroute CL3050 until an acceptable signal
strength is found.
Red LED
On
On
On
On
On
Flash
4
Route Wiring to Mounting Location
Route wiring from the hardwired zones or control panel as required.
NOTE: Route wiring through conduit to a junction box if possible. Mount the
Skyroute Panel.
Yellow LED
On
On
On
Flash
Off
Off
*Minimum recommended signal strength for enrollment
to RED & BLK terminals.
DC
Green LED
On
Flash
Off
Off
Off
Off
3
Signal Strength
>87%
69-87%
*52-68%
34-51%
16-33%
0-15%
Advertisement
Table of Contents
