Table of Contents
Advertisement
Figure 15 shows the display immediately after resetting the unit to its factory
default settings (by pressing the OUT buttons 1, 2 and 3). The display
indicates the machine menu for a few seconds, displays the firmware version
and then returns to the machine default setting display (IN 1 switched to OUT
1, IN 2 switched to OUT 2, and so on).
Firmware
version #
Figure 15: 7-segment Display following Factory Default Reset
7.3.2
The REL AUDIO LEVEL 7-segment Display
The REL AUDIO LEVEL display, as illustrated in Figure 16, is active only in
the AUDIO and AFV modes (see section 7.8).
7.4 Confirming Settings
You can choose to work in the At Once or the Confirm mode.
In the At Once mode (TAKE button does not illuminate):
Pressing an OUT-IN combination implements the switch immediately
You save time as execution is immediate and actions require no user
confirmation
No protection is offered to allow the correction of an erroneous action
before it is implemented
Operating the VP-8x8A
Machine #
Figure 16: REL AUDIO LEVEL 7-segment Display
Machine
name
21
Advertisement
Table of Contents
