Test 3 Motor Test - Kenmore 796.8051 Service Manual

Electric & gas dryer
Hide thumbs Also See for 796.8051:
Table of Contents

Advertisement

Test 3
Motor test
In diagnostic test mode, press the
START / PAUSE button. Is the
voltage 120 VAC between WH1-
1(WH) and BL3-1 (BN)?
YES
With the connectors disconnected,
check the resistance between WH1-
1 (WH) and BL3-2 (BN). Is the
resistance 2-4 Ω ?
Measure with the door closed.
NO
With the connectors disconnected,
check the resistance between WH1-
1 (WH) and BL3-3 (YL). Is the
resistance 0 Ω ?
Measure with the door closed.
YES
With the connectors disconnected,
check the resistance between BL2-1
(BN) and BL3-3 (YL). Is the
resistance 2-4 Ω ?
Measure with the door closed.
NO
With the connectors disconnected,
check the resistance between the
terminals of the thermal fuse on the
blower housing. Is the resistance 0
Ω ?
YES
Is the arm of the idler pulley
contacting the belt switch lever?
(Normal operating position is NO
CONTACT.)
With the connectors disconnected, check
the resistance between terminals 1 and 2
(N.O.) of the belt switch on the motor
mount. Is the resistance <1 Ω with no
switch contact?
YES
• Check Motor. (Refer to MOTOR DIAGRAM AND SCHEMATIC.)
• Check if control connector is plugged in.
21
• Replace main
PCB
NO
• Recheck voltage at
main PCB and
replace if no
YES
voltage.
• Check door switch
activation.
• Check wiring
harness and
NO
connections.
• See DOOR
SWITCH TEST #5.
• Recheck voltage at
main PCB and
YES
replace if no
voltage.
• Replace the outlet
thermal fuse.
• Check the thermistor
(test # 3).
NO
• Check exhaust
system for restrictions.
• Check idler pulley
and arm.
• Check drum belt
condition
YES
(stretched/broken)
• Check drum belt
routing
• Replace the belt
NO
switch.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 796.8051 and is the answer not in the manual?

This manual is also suitable for:

796.9051Elite 796.9051 series

Table of Contents

Save PDF