Wheels & Tyres; Circuit Breaker & Fuse - Shoprider -778 Series Owner's Manual

Care & Maintenance
figure 13
page 15
WHEELS AND TYRES (figure 13)
All SHOPRIDER™ scooters have split-
rim wheels.When changing a wheel,
please remove central bolt and then
remove wheel. Replace with
new/repaired wheel and tighten the
central bolt.
( W h e n c h an g i n g a t y re y o u
m u s t d e fl a t e t h e t y re ).
Remove the centre bolt after deflation
and then remove the remaining four
bolts.
TYRE PRESSURE – 10", 12" and 14":
Maximum 30 psi on the rear tyres,
26 psi on the front tyres.
NOTE: On the tyre itself it states maxi-
mum tyre pressure is 50 psi.This is a
maximum tyre pressure and the tyres
should never be inflated to this pressure.
Attention - Tyres should be maintained
at the correct pressure noted to
ensure even wear and ride comfort
CIRCUIT BREAKER & FUSE
If your scooter stops for no apparent
reason, it is probably due to the circuit
breaker located on the main control
box.This is located under the seat
through a hole on the top of the rear
shroud.
Occasionally, there is a temporary
overload on the electric circuit. If this
occurs, the circuit breaker will pop out.
It is merely a matter of pressing the
circuit breaker button back in.
To do this, turn your key to the OFF
position, press circuit breaker button,
then turn the key to the ON position.
Your scooter also has a fuse to protect
the electronics of the SHOPRIDER™.
This is located on all models of the
SHOPRIDER™ also in the main con-
trol box.
If you have no power, reset your circuit
breaker, the next thing to check is your
fuse. Simply unscrew the cap and
remove the fuse.
If the fuse is blown replace it with a
new fuse.The rating of the fuse is a 2.5
amp.This fuse can be purchased at any
electronics shop or local Shoprider
dealer.
IF THE SCOOTER STILL DOES NOT RUN,
CONTACT YOUR CLOSEST AUTHORISED
SHOPRIDER™ DEALER.