Brother MFC-9840CDW User Manual page 142

Error Message
No Response/Busy
No Tray
No Waste Toner
Not Registered
Out of Memory
Print Unable XX
(XX=Error Code)
Protected Device
132
Cause
The number you dialled does
not answer or is busy.
The paper tray is not
completely closed.
The waste toner box is not
installed.
You tried to access a
One-Touch or Speed Dial
number that is not
programmed.
The machine's memory is full.
The machine has a
mechanical problem.
The protect switch of the USB
flash memory drive is On.
Action
Verify the number and try again.
Close the paper tray properly.
Install the waste toner box. (See Replacing the
waste toner box on page 184.)
-
Set up the One Touch or Speed Dial number.
(See Storing one-touch dial
numbers on page 59 and Storing speed-dial
numbers on page 60.)
Fax sending or copy operation in progress
Do one of the following:
Press Mono Start or Color Start to send or
copy the scanned pages.
Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
Clear the data from the memory. (See Out of
memory message on page 46 or page 85.)
Print operation in process
Do one of the following:
Reduce print resolution. (See Advanced tab
in the Software User's Guide on the
CD-ROM.)
Clear the faxes from the memory. (See Out
of memory message on page 85.)
'
Turn off the machine s power switch and then
turn it on again. If the error message continues
leave the machine for several minutes and then
try to print, copy or scan again. The machine can
be turned off for up to 60 hours without losing
faxes stored in the memory. (See Checking if the
machine has faxes in its memory on page 135.)
Turn off the protect switch of the USB flash
memory drive.