Panasonic Lumix DMC-G1K Operating Instructions Manual page 149

Others
-The LCD monitor turns off when [AUTO LCD OFF] (P31) is selected for the [ECONOMY] mode.
[This does not happen when using the AC adaptor (P132).]
If the remaining battery power is low, it may take longer for the flash to be charged, and the
time during which the LCD monitor is turned off may become longer.
- It will switch to viewfinder display if there is hand or object near the eye sensor. (P37)
~~~;i)ji;;;';.".;;.'·"··'
~
Adjust the brightness of the LCD monitor/viewfinder to a proper level. (P31)
- [POWER LCD] is activated. (P31)
- Does the picture appear on the Viewfinder?
~
Press [LVF/LCD] button to switch to LCD monitor display. (P37)
-Is the LCD monitor switched off?
~
Switch the display by pressing [DISPLAY]. (P54)
-Is the [EXPO. SETIINGS] set to [SWITCH BY PRESSING THE LVF/LCD BUTTON]? (P108)
-It is only displayed on the LCD monitor when the camera is connected to a PC or printer.
- This is not a malfunction.
These pixels do not affect the recorded pictures.
-In dark places, noise may appear to maintain the brightness of the LCD monitor. This does not
affect the pictures you are recording.
- The LCD monitor may flicker for a few seconds after turning the camera on indoors under
fluorescent light. This is not a malfunction.
- This is characteristic of MOS sensors which serve as the camera's pickup sensors.
This is not a malfunction. This does not affect the pictures you are recording.
VQT1U32
149