Panasonic Lumix DMC-G1K Operating Instructions Manual page 114

Advanced (Playback)
_Note
• The number of prints can be set from
a
to 999.
• With a printer supporting PictBridge, the date print settings of the printer may take precedence
so check if this is the case.
• It may not be possible to use the OPOF print settings with other equipment. In this case, cancel
all the settings, and reset the settings.
• If the file is not based on the OCF standard, the OPOF print setting cannot be set.
You can set protection for pictures you do not want to be deleted by mistake.
Select [PROTECT] on the [PLAYBACK] mode menu. (P27)
Press
./T
to select [SINGLE] or [MULTI] and then
press [MENU/SET].
[SINGLE] [MULTI]
Select the picture, and then
press [MENU/SET].
When [MULTI] has been selected
• Repeat these steps for each picture.
• The settings are canceled when [MENU/
SET] is pressed again.
Press
~/~
to select Press
A/T /~/~
to
the picture. select the pictures.
D
Press [lID] to return to the menu screen.
• Press [MENU/SET] to close the menu .
• Canceling all the [PROTECT] settings
1 Select [CANCEL] on the screen shown in step 2 and then press [MENU/SET].
2 Press A to select [YES] and then press [MENU/SET].
3 Press [MENU/SET] to close the menu.
·If you press [MENU/SET] while canceling protection, the canceling will stop halfway.
ONate
• The protect setting may not be effective on other equipment.
• Even if you protect pictures on a card, they will be deleted if the card is formatted.
• Even if you do not protect pictures on an SO Memory Card or an SOHC Memory Card, they
cannot be deleted when the card's Write-Protect switch is set to [LOCK].
114
VQT1U32