Preparrng The Remote Control; Rf Remote Control Function (For Vr-6060 Only) - Kenwood VR-6060 Instruction Manual

Settinrr UR the system
Loading the batteries
0 Remove the cover. 6 Insert the batteries.
Q Close the cover.
l
Insert two AA-size (R6) batteries as indicated by the polarity ImarkIngs
RF
r@fI?Ofe COnfrO/ fUI?CfiOn
(FOG
~~-6060
0nl~4
The remote control has the RF remote fuvctlon I" addltlon to the IR
remote function The VR-6060 can receive the remote control com-
mands even when they are lnstalied in a posItIon where the IR remote
signal can hardly access, for example InsIde a cabinet The receiver IS not
equipped with the RF remote bi-dIrectIonal communlcatlon function The
bi-directional communication IS avaIlable only when using the IR remote
function with equipments other than the recelver
Changing the RF transmission frequency
The RF remote function may be unavatlable due to radio wave cross talk,
etc In this case, the transmlsslon frequency can be changed
To change the RF remote transmission frequency:
0 Change the RF switch setting
Aftel changing the RF frequency of remote control, be also sure to
change that of the receiver
0 Change the receiver's RF reception frequency.
* Press and hold the SETUP key on the front panel of the receiver
for more than 2 seconds
Each timeyou press theSETUP key, the RF reception frequency
changes as follows
L-
1 "RF REMOTE BAND 1 I
2 "RF REMOTE BAND 2"
3
"RF REMOTE OFF"
-%ect the same number as the posItIon number of the RF
switch of the remote control
Remote control operation
When the STANDBY lndlcator IS Itt. the power turns ON when you press
the POWER (0) key on the remote control. When the power comes ON,
press the key you want to operate.
Operating
other component range IIR Transmitted
I
jm
IR Transmitter
Operating receiver range (RF Transmitter)
RF Remote antenna
l
The remote control stgnal recerved by mafn unit IR and RF signals.
l
When pressing more than one remote control key successively, press the
keys securely by leaving an Interval of 1 second or more between keys.
Notes
1 The supplled batteries may have shorter ltves than ordinary batteries
due to use during operation checks.
2 When the remote-controllable distance gets shorter than before, re-
place both batteries with new ones.
3 Placing the remote sensor I" direct sunlight. or in direct light from a
high frequency fluorescent lamp may cause a malfunction.
In such a case, change the locatlon of the system lnstallatlon to pre-
vent malfunction
Important notes
Here is list of adjustment which can maximize the operation of
your remote control. For optimal operation of the remote control:
1 Aim the remote control toward the room where the receiver IS
located
i Do not posltton the receiver and remote control near metal (such
as heat ducts) Metal cat- absorb RF signals
3 Make sure the batteries I" the remote control are fully charged
Weak battetles WIII affect the range of the remote control.
4 When there IS an obstruction around other equipments that send
signal from the remote control, the control distance of the RF
remote slgnal WIII be short
Note
l
The tests for range limits of the remote control and the recever are
conducted in open-afr distance test. Actual distance of the slgnal will
be based on the construction of the bulldIng where the unit IS being
used I" as well as other factors such as outside Interference
lgEN