Recording; Recording Audro (Analog Sources); Recordrng Vrdeo - Kenwood VR-6060 Instruction Manual

Recording
audirr (analog sources)
MD/TAPE
Recording a music source
0 Use the Input Selector keys to select the source (other than "MD/
TAPE") you want to record.
0 Set the MD or TAPE recorder to record.
0 Start playback, then start recording.
0 Use the Input selector keys to select the video source (other than
"VIDEO 1") you want to record.
0 Set the video deck connected to VIDEO 1 to record.
l
Select the REC MODE to record a drgrtal Input source
0 Start playback, then start recording.
l
Recordrng may not be normal for some video software This IS due
to the copy guard condrtron ->B
audio (digital sources)
Svwtch 011 the REC MODE to record a drgital input source
Usually lose
tile
AUTO REC MODE to record audio Input sources When
the dIgItal n?otie changes durlrng recordrng in the AUTO REC MODE, the
audro Input sowce may be rntenupted momentarily
Recording music in AUTO REC or MANUAL REC mode
DIMMER
I
lnpui Selector
0 Use the Input Selector keys to select the source (CD/DVD,
DVD/GCH, VIDEO 2, VIDEO 3) you want to record.
0 Set the MD or TAPE recorder to record.
0 Press and hold the DIMMER key for more than 2 seconds to
select the AUTO REC or MANUAL REC mode.
1
I REC MODE off : The drgrtal Input record mode is
switched off.
2 AUTO REC mode
: The drgrtal input signals (DTS, Dolby
Drgrtal, or PCM) are identified auto-
matically and converted Into stereo
srgnals that are ready for recording.
3 MANUAL REC mode : The input srgnal type at the moment
thus mode IS selected is held through-
out this mode.
I 8
rnfJ8
0" omc'L
~ u fjfl fl 1;;; 1) #.J 111 ',,I' :I::i' *yY&yy
0 Start playback, then start recording.
l
If the audio reproductron stops rn the mrddle due to change in the
Input signals, etc , press the DIMMER key
25 EN