Table of Contents
Advertisement
Remote control operation
@ Operations
1. Connect the power plug of the receiver to an AC outlet.
@ The receiver enters the power standby mode and the
POWER/STANDBY
indicator lights.
2. Press the POWER
key of the remote control unit or the
POWER switch of the receiver.
®@ The receiver enters the power ON mode.
3. The various functions of the receiver can be operated
with the keys of the remote control unit.
Note for remote contro! operation
After pressing one of the operation keys, when the next
operation is required, press the next operation key firmly
after an approx.
1 second interval.
If the next operation key is pressed immediately after the
previous key, misoperation may result.
Hf Installing the batteries in the remote control
unit
1. Remove the battery compartment cover.
2. Insert two size ''AA"' (R6) batteries confirming the cor-
rect polarity and close the cover in its place.
Note:
The provided batteries are to be used for checking the operation
of the remote control unit, and they may have a short life. When
the remote control unit becomes effective only for short distances
or does not operate properly, replace the batteries with two new
batteries.
@ Operating range of the remote control unit
The operating range of the remote control unit may differ ac-
cording to temperature, humidity, or using conditions, however,
it is defined approximately as shown in the figure below:
For controlling audio
The signai transmission system used
by this remote control unit is the in-
frared contro! system.
KR-V6020 (En) 19
Advertisement
Table of Contents
