Toshiba B-EX4 T1 Series Product Description page 46

2. SUPPLY SPECIFICATIONS
5) Cutter
When an RFID label or tag is used in cut issue mode, care must be taken not to cut the antenna or
the IC chip of an RFID tag in order not to damage the cutter.
6) Static Electricity
When printing is performed in a place where humidity is low or under some specific conditions,
writing data on an RFID tag may fail due to static electricity generated by a label or a ribbon.
7) Printing on Bump (Chip/Antenna) Area
Embedding RFID tags in labels creates bumps in a chip/antenna area in the labels, causing
incomplete printing.
Especially, in the areas 5 mm from and left and right sides of the RFID-tag embedded area shown
in the figure below, uneven printing or incomplete printing can occur easily.
* The degree of poor printing quality differs depending on height of a chip/antenna used.
Print quality on
the IC chip is not
guaranteed.
8) Ambient temperature
Low operating temperature deteriorates wireless performance, under which conditions writing data
on an RFID tag may fail.
9) Strip issue
Stripping performance in strip issue mode depends on the type of glue, tag, and backing paper.
For some RFID supplies used, an issue may not be performed properly in strip issue mode.
RFID tag
embedded
area
2.8 SPECIFICATION OF RFID TAG (for B-EX700-RFID-U2-CN-R)
Print quality on
bumps is not
guaranteed.
Print quality on the
sides of RFID tag is
not guaranteed.
Print quality on
bumps
guaranteed.
5mm
2-30
Media
feed
direction
5mm
is not
SPTM-0152