Specification Of Rfid Tag (For B-Ex700-Rfid-H1-Qm-R) - Toshiba B-EX4 T1 Series Product Description

2. SUPPLY SPECIFICATIONS

2.5 SPECIFICATION OF RFID TAG (for B-EX700-RFID-H1-QM-R)

2.5.1 General Description
The RFID supplies are RFID tag (wireless IC tag) inlays designed to be converted into tag and label
applications. Printers, which are equipped with an RFID kit, can print data on the surface of RFID tags
as well as write data on them.
The B-EX series optional RFID kit, B-EX700-RFID-H1-QM-R, is destined for Europe and operates in
the UHF band 13.56MHz.
(RFID module and antenna are locally purchased.)
Although the specified frequency band can be used in the other countries than Europe, the destination
is limited to Europe because the certification is obtained only for Europe.
NOTE: Regarding the specification of RFID supplies and the ribbon used for printing on them, refer to
Section 2.1 MEDIA and Section 2.2 RIBBON.
2.5.2 Available RFID Tag
•
TagSys C210, C220, C240, I-Code, Tag-it, ISO15693
2.5.3 Location of RFID Tag
The location of an RFID tag on a label influences on the accuracy of writing data on the RFID tag.
It is impossible to define the one best location for every RFID tag on labels because the best location
depends on the type of RFID tag and RFID tag antenna.
The B-EX RFID Analyze Tool can evaluate the accuracy of writing data on the RFID tag. For the
usage of this tool, refer to the B-EX RFID Analyze Tool Operation Specification.
2.5.4 Cautions for using RFID Tags
1) Lift-up of Print Head
An RFID tag chip or the print head may be damaged when the print head passes over the chip.
This can be prevented by using the ribbon saving module (standard feature for the B-EX6T and
optional for the B-EX4T). The print head is lifted by the ribbon saving module when it passes over
the chip to prevent it from touching the chip.
The print head is lifted by approximately 1 mm from the platen.
2) Storage of RFID Supplies
Do not store RFID tags close to printers, or their communication performance may not be as
specified when they are used.
3) Roll-type RFID Supplies
When RFID supplies are to be rolled, roll hardness must be concerned.
Although it depends on the type of glue, tag, and backing paper, RFID-tag embedded labels tend to
stay rolled. Especially, when they are wound outside, a media jam error may occur. Unless
otherwise specified, it is recommended that the RFID-tag embedded labels be wound inside.
4) Sensor
When the transmissive sensor or reflective sensor is enabled, transmissivity or reflectivity of a label
or tag may vary at an RFID-tag embedded area depending on the pattern of an antenna or other
factors. In such cases, a manual threshold setting is required in Online mode. For details, refer to
the B-EX Key Operation Specifications.
2.5 SPECIFICATION OF RFID TAG (for B-EX700-RFID-H1-QM-R)
2-18
SPTM-0152