Toshiba B-EX4 T1 Series Product Description page 19

2. SUPPLY SPECIFICATIONS
NOTES:
1. For label issues, set the head lever to position
2. For tag issues, set the head lever to position
3. When using narrow paper, may need to set the head lever to position
right head pressure.
4. The ratio of "Label length" to "Gap length" must be 3:1 or more.
5. The backing paper is approved together with label.
6. The paper width for the label includes its backing paper.
7. The backing paper to be used must be glassine paper (white or 7K) or equivalent, and must have a
transmission factor of 22% or more.
8. A label showing "TEC", item code, and lot number must be attached to the paper core inside.
For reference;
Relationship between Paper Roll Length and Paper Core Diameter
9. In the cut issue mode, the backing paper of labels (the gap between labels) can be cut. The label
itself cannot be cut. When the perforated label is used, it is necessary to test and confirm the cutting
performance beforehand.
10. In the cut issue mode, the gap length must be 6 mm or more, and the cut position must be adjusted
so that the cutter cuts in the center of the gap.
11. When the stop position is not proper, the print stop position should be changed by the strip position
fine adjustment.
12. When the gap between labels is 5 mm or more, the effective print length should be set to the
maximum value (Label pitch minus 2 mm), then the print stop position should be changed by the
strip position fine adjustment.
13. When the rotary cutter is used, a cut and issue should be performed with the head-up operation
being activated by using ribbon save unit together.
14. If paper is jammed at the platen when cut issue is performed, enable the forward feed function
("FORWARD WAIT") in system mode.
15. When the paper thickness is more than 200 µm, the print head installation position may need to be
changed.
LABEL.
TAG.
Label showing "TEC",
item code, and lot number
Paper
Label roll dia.
core ID
(Paper roll dia.)
2-3
TAG, or need to adjust the
2 2
) π
(D - d
L =
4t
L: Paper length
D: Paper roll diameter
d: Paper core outside diameter
t: Paper thickness
In calculation, the unit of each factor must be
the same.
SPTM-0152
2.1 MEDIA (Paper)