Toshiba B-EX4 T1 Series Product Description page 39

2. SUPPLY SPECIFICATIONS
7) Printing on Bump (Chip/Antenna) Area
Embedding RFID tags in labels creates bumps in a chip/antenna area in the labels, causing
incomplete printing.
Especially, in the areas 5 mm from and left and right sides of the RFID-tag embedded area shown
in the figure below, uneven printing or incomplete printing can occur easily.
* The degree of poor printing quality differs depending on height of a chip/antenna used.
Print quality on
the IC chip is not
guaranteed.
8) Ambient temperature
Low operating temperature deteriorates wireless performance, under which conditions writing data
on an RFID tag may fail.
9) Strip issue
Stripping performance in strip issue mode depends on the type of glue, tag, and backing paper.
For some RFID supplies used, an issue may not be performed properly in strip issue mode.
10) Caution for minimum label pitch length
When short-pitch media is used, data may be written on a next RFID tag instead of the target
RFID tag.
As the location, where data is to be written, differs among RFID tag types, a check must be
performed using the labels to be used to make sure that the data is written on the target RFID tags.
The RFID Analyze Tool (7FM001113) can be used for this purpose.
RFID tag
embedded
area
2.6 SPECIFICATION OF RFID TAG (for B-EX700-RFID-U2-EU-R)
Print quality on
bumps is not
guaranteed.
Print quality on the
sides of RFID tag is
not guaranteed.
Print quality on
bumps
guaranteed.
5mm
2-23
Media
feed
direction
5mm
is not
SPTM-0152