AMT Datasouth Fastmark M5 Plus Series User Manual page 37

Printer
Initialization
Black Mark Sensor
Calibration
Gap Sensor
Calibration
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns
blinks. (Any green will do during the 5 blinks).
The LED color will be changed as following:
Amber
blinks)
blinks)
Always do gap/black mark sensor calibration
printer initialization.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns
green blinks. (Any green/amber will do during the 5 blinks).
The LED color will be changed as following:
Amber
blinks)
blinks)
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns
green/amber blinks. (Any red/amber will do during the 5
blinks).
The LED color will be changed as following:
Amber
blinks)
blinks)
red (5 blinks) amber (5 blinks)
green/amber (5 blinks)
solid green
red (5 blinks) amber (5 blinks)
green/amber (5 blinks)
solid green
red (5 blinks) amber (5 blinks)
green/amber (5 blinks)
solid green
35
green after 5 amber
green
red/amber (5
after
green/amber after 5
green (5
red/amber (5
red/amber after 5
green (5
red/amber (5
(5