AMT Datasouth Fastmark M5 Plus Series User Manual page 36

Gap/Black Mark
Sensor Calibration
Gap/Black Mark
Sensor Calibratio,
Label Length
Measurement,
Self Test and enter
Dump Mode
1.Turn off the power switch.
2. Hold on the button then turn on the power switch.
3 Release the button when LED becomes
red will do during the 5 blinks).
It will calibrate the gap/black mark sensor sensitivity.
The LED color will be changed as following order
Amber
(5 blinks)
blinks)
It calibrates the sensor and measures the label length.
Note:
Please select gap or black mark sensor by GAP or BLINE
command prior to calibrate the sensor.
For more information about GAP and BLINE command,
please refer to programming manual.
1.Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED becomes
(Any amber will do during the 5 blinks).
The LED color will be changed as following order.
Amber
(5 blinks)
blinks)
It calibrates the sensor and measures the label length
and prints internal settings then enter the dump mode.
Note:
Please select gap or black mark sensor by GAP or BLINE
command prior to calibrate the sensor.
For more information about GAP and BLINE command,
please refer to programming manual.
red (5 blinks) amber (5 blinks)
green/amber (5 blinks)
solid green
red (5 blinks) amber
green/amber (5 blinks)
solid green
34
red and blinking. (Any
green
red/amber (5
amber and blinking.
(5 blinks) green
red/amber (5