AMT Datasouth Fastmark M5 Plus Series User Manual page 16

8. Hold the lower cover and lift up the lower inner cover.
9. Thread the cutter module cable through the bezel.
10. Connect the cutter module cable to the 4-pin socket on printer PCB.
Socket
11. Reassemble the lower inner cover back onto the lower cover.
12. Install the cutter module into the slots of the printer.
13. Reassemble the parts in the reverse order.
14. Close the top cover.
Fig. 16 Cutter module harness arrangement
Fig. 17 Cutter module installation
14
Bezel
Slots each side of
the printer