Installation; Installation Overview; Rear Panel Features - Extron electronics HDMI DA2 User Manual

Installation

This section of the guide describes the following topics concerned with the installation and
setup of the HDMI DA2 distribution amplifier.
z
z
z
z
z
z
z

Installation Overview

To install and set up the HDMI DA2, follow these instructions:
1.
2.
3.
4.
5.
6.

Rear Panel Features

Figure 2.
a
b
c
d
Installation Overview
Rear Panel Features
Connecting the Power Supply
Connecting the Input Source
Connecting Output Displays
Wiring for RS-232 Control
Connecting to the USB Port
Mount the HDMI DA2 in a suitable location (see page 27).
Connect the provided 12 VDC power supply
all attention points, notes, and warnings in this section before powering up the HDMI DA2
(see page 4).
Connect the display devices
The distribution amplifier automatically reads and stores EDID from the display connected
to output 1.
If necessary, connect a control PC to the
front panel USB port
page 6) or the
Configure the HDMI DA2, using
Connect and power on the input device
POWER
12V
1
0.4A MAX
INPUT
a b c
HDMI DA2 Rear Panel
Power supply connector
HDMI input connector
HDMI output connectors
RS-232 connectors
to the power connector. Be sure to read
to the HDMI DA2 and power them on (see page 5).
rear panel captive screw connector
(see page 7).
SIS commands (see page 17).
(see page 5).
REMOTE
2
RS-232
Tx Rx G
OUTPUTS
d
HDMI DA2 • Installation
(see
3