Xantrex XTR 6-110 Operating Manual page 191

:PROG:STAT RUN
The output after the last command might be as follows:
Xantrex, XTR 150-5.6, SN# E00123456, 1.00 Build 10,
21/11/2005
Xantrex, XTR 150-5.6, SN# E00123456, 1.00 Build 10,
21/11/2005
Important:
pressing the Esc key in the MS Windows Hyper Terminal window. The power
supply can be controlled during program execution.
Deleting an Auto Sequence Program:
It is possible to delete the current Auto Sequence Program using the SCPI
noted below.
Command:
[:]PROGram[<channel>]:DELete[:ALL]
Repeating an Auto Sequence Program:
An Auto Sequence Program can be configured to repeat any number of
times or infinitely. The default at power up is to have the repeat count
default to once. The program will repeat if the repeat count can be
changed using the :PROGram[<channel>]:REPeat command. If a
program is running or pause the :PROGram[<channel>]:REPeat
command will not work.
Commands:
[:]PROGram[<channel>]:REPeat {?|<count>|INFinity}
Where:
<count> is the repeated count from 1 to 65 534.
INFinity is the character mnemonic for repeating without end.
For Example:
:PROG:STAR
*IDN?
*IDN?
:PROG:STOP
M370046-01
Locking and Unlocking the Front Panel
Execution of the program may be terminated at any time by
5
5-65