Replacing The Centre Belt - Husqvarna Rider Pro 18 AWD Operator's Manual

17. Fit the belt guide for the centre belt.
18. Hook the spring on the belt tensioner.

Replacing the Centre Belt

1. Remove the hose clip in the middle (Pro 15,
Pro 18) and the rear belt guide for the centre
belt (all machines).
2. Remove the centre belt and fit a new belt.
3. Fit and adjust the belt guide with the lower belt
on the engine belt pulley. On Pro 15, Pro 18 also
fit the hose clip in the middle as in the figure
above.
4. Check and adjust the belt tensioner. This is
especially important when fitting a new belt,
since stretching of the old belt may have been
compensated for by changing the setting of the
belt adjuster.
40
– English
MAINTENANCE
8009-727
8009-637
8009-364
8009-727
8009-401