Table of Contents
Advertisement
Checking the Parallelism of the Cutting
Unit
Check the cutting unit's parallelism as follows:
1. Check the air pressure in the tyres
60 kPa / 0.6 bar / 9 PSI.
2. Place the Rider on a flat surface.
3. Put the lifting lever in the mowing position.
4. Measure the distance between the ground and
the front and back edges of the unit's cover.
The cutting unit should have a slight slant, with
the rear edge 2–4 mm (1/8") higher than the
front edge.
Adjusting the Parallelism of the Cutting
Unit
1. Remove the front cover and the right-hand wing
cover.
2. Loosen the nuts on the parallel strut.
3
Screw out (extend) the strut to raise the rear
edge of the cover.
Screw in (shorten) the strut to lower the rear
edge of the cover.
4. Tighten the nuts after adjustment.
5. The parallelism of the cutting unit should be
checked again after the adjustment has been
made.
6. Fit the right-hand wing cover and the front
cover.
46
– English
MAINTENANCE
6017-217
6017-018
Hide quick links:
Advertisement
Table of Contents
