Table of Contents
Advertisement
12 INFRA-RED REMOTE CONTROL
Note: please refer to your specific product section for information on how to lock out
the infra-red remote control – for cases where another unit shares the same codes.
If the unit is connected to a C2 unit, the infra-red control buttons
may have no effect and the units settings may be under the
control of the C2 unit.
12.1 S2-106AD operation
When operating your unit using a remote control handset, the reset button resets the
units internal processor, the channel buttons are used to select the input to route to
the outputs (see diagram below for channel numbers) and the up and down, left and
right arrows are used to adjust the volume and balance respectively depending on
the features available on the model.
12.2 S2-101AA operation
When operating your unit using a remote control handset, the up and down arrows
are used to adjust the volume of the output.
12.3 Video switcher operation
Video switcher input selection
buttons as shown –
corresponding to a 'telephone
keypad' on the first 4 full rows of
buttons.
Pressing the button associated
with an input directly selects that
input.
RESET will reset the unit.
12.4 Purchasing an infra-red controller
It is recommended that a remote control handset is purchased from TV One as these
will readily control any unit in the S2 range. Please contact TV One using the
http://www.tvone.com/support website for more information.
Alternatively most universal infra-red controllers can be programmed to control any
unit in the S2 range. The unit will respond to an NEC code set and it is
recommended that when purchasing a handset that you ensure it supports at least
one NEC code set.
RESET
1
2
4
5
7
8
10
43
3
6
9
Advertisement
Table of Contents
Need help?
Do you have a question about the S2-101AA and is the answer not in the manual?