Option Cable Control; Remote Control; Locking Out The Ir Remote Control - TV One S2-101AA Operation Manual

Please refer to the 'RS232 control' section for more information.

7.5 OPTION cable control

The S2 series of switchers have been designed to support networked control in
conjunction with C2-1000 or C2-2000 series units when connected via an OPTION
cable provided with the switcher.
When you connect your unit to a C2 unit via an OPTION cable, the video source
menu on the C2 unit will expand to reflect the extra inputs available on the switcher.
A single OPTION cable connecting the unit to a C2 unit will provide power to the unit
without the need for a separate power supply.
If you are connecting your unit to a C2-1000 or a C2-2000 series video processor,
you must connect your unit's video output to the video connector with the highest
number as shown in the following diagrams for the C2-1000 & C2-2000:
If your C2 unit has only one YC input then connect it to this input as shown:
In the case of an S2-105YC, selecting S2-YC1 to S2-YC5 on the scaler will now
route inputs 1 to 5 on the switcher through to the C2 unit.
Please refer to the 'OPTION cable control for multiple units' section for more
information.

7.6 Remote control

Your unit comes fitted with infra-red control capability, however infra-red controllers
are not shipped with the S2 switcher range as standard.
Please refer to the 'Infra-red remote control' section for more information.

7.7 Locking out the IR remote control

When powered up, your S2 unit will be responsive to a remote control handset by
default. The responsiveness of the S2 unit can be disabled simply by pressing
26