The electric motor has been designed for 230 - 240V only. Always check that the power supply corresponds to the voltage on the rating plate. Note: The supply of 230V and 240V on Ozito tools are interchangeable for Australia and New Zealand.
Page 5
GENERAL Warning! Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “Power Tool” in all of the warnings listed below refers to your mains operated (corded) power tool or battery operated (cordless) power tool. SAVE THESE INSTRUCTIONS 1) WORK AREA a) Keep work area clean and well lit.
Page 6
GENERAL (cont.) e) Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations. Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts.
Page 7
SAFETY INSTRUCTIONS FOR SPADE HANDLE DRILLS Before drilling into walls, ceilings etc, ensure there are no concealed power cables or pipes in the cavity. Always use the side or spade handle, this gives you greater control should an accessory become jammed. Keep the cord clear of the accessory being used, do not wrap the cord around your arm or wrist.
OPERATION Warning! Always turn off the tool and disconnect from the power supply prior to change any accessories or making any handle adjustments. Side Handle The side handle will provide additional control, support and guidance when using the tool. The side handle can be assembled to the left, top or right side of the metal gear casing.
Page 9
This feature is intended for use when the drill has been mounted in a drill stand or otherwise firmly held, not by hand (drill stand not manufactured by Ozito). Avoid locking the switch 'ON' when drilling by hand so that you can always instantly release the trigger should the bit bind in the hole.
Page 10
OPERATION (cont.) Variable Speed Dial The trigger switch has a variable speed dial. By rotating the dial you are able to limit the maximum speed of the drill. See the dial for the direction of which to rotate for higher or lower speeds. Forward/Reverse Lever The direction of the chuck is controlled by the forward/reverse lever located above the switch.
Agent for quick and low cost replacement. Always replace both brushes at the same time. Note: Ozito Industries will not be responsible for any damage or injuries caused by the repair of the tool by an unauthorised person or by mishandling of the tool.
Reuse of recycled material decreases pollution in the environment. Please recycle packaging where facilities exist. Check with your local council authority for recycling advice. CONTENTS 1 x Spade Handle Drill OZSHD1050WA 1 x Spade handle 1 x Auger bit 1 x Chuck key...
PURCHASED FROM:__________________________________________________ DATE PURCHASED: __________________________________________________ 3 YEAR REPLACEMENT WARRANTY Your Ozito tool is guaranteed for a period of 36 months from the original date of purchase and is intended for DIY (Do it yourself) use only. WARNING The following actions will result in the warranty being void.