Subscribe to Our Youtube Channel
Related Manuals for Ozito DDG-560V
Summary of Contents for Ozito DDG-560V
- Page 1 Drill Driver 280 Watt Operation Manual 3 Year Replacement Warranty DDG-560V 0209 www.ozito.com.au To view the full range visit:...
- Page 2 SPECIFICATIONS - MODEL NO. DDG-560V Motor: 280W Input: 230V ~ 50Hz No load speed: 0 - 750rpm Chuck: 10mm Features: Torque control Variable speed reversing Keyless chuck 1. 10mm Keyless chuck 4. Variable speed switch 2. Torque adjustment 5. Forward/reverse lever...
-
Page 3: Safety Instructions
The electric motor has been designed for 230V and 240V only. Always check that the power supply corresponds to the voltage on the rating plate. Note: The supply of 230V and 240V on Ozito tools are interchangeable for Australia and New Zealand. - Page 4 GENERAL 1. Keep work areas clean. Cluttered work areas and benches can cause accidents. 2. Consider work area environment. Do not expose your tool to high humidity or rain. Do not use your tool in damp or wet conditions. Keep the work area well lit.
- Page 5 GENERAL (cont.) 13. Check for damaged parts. Before use carefully check the tool and power lead for damage. Check for misalignment and seizure of moving parts, breakage of parts, damage to guards and switches and any other conditions that may affect its operation.
- Page 6 SAFETY INSTRUCTIONS FOR DRILL DRIVERS Keep the cord clear of the drill accessory; do not wrap the cord around your arm or wrist. When possible, always use clamps or a vice to hold the work piece. Always switch the tool off before you put it down. Only use accessory bits which are in good condition.
-
Page 7: Operation
OPERATION Keyless Chuck A keyless chuck has been provided on your drill driver to allow for easy installation and removal of bits. The chuck is divided into two parts, the rear is called the collar and the front is the body, to open and close the chuck: •... - Page 8 OPERATION (cont.) Warning! If the lock on button is engaged when the tool is connected to a live mains power supply, the tool will start immediately. This could result in serious bodily harm or material damage. Always squeeze and release the switch to ensure the lock on button has been disengaged prior to connecting the tool to the power supply.
-
Page 9: Maintenance
Always replace both brushes at the same time. Note: Ozito Industries will not be responsible for any damage or injuries caused by the repair of the tool by an unauthorised person or by mishandling of the tool. - Page 10 CONTENTS 1 x Drill Driver DDG-560V 1 x Instruction manual OZITO INDUSTRIES PTY LTD AUSTRALIA (Head Office) 1 - 23 Letcon Drive, Bangholme, Victoria, Australia 3175 Telephone: 1800 069 486 Facsimile: +61 3 9238 5588 Website: www.ozito.com.au Email: enquiries@ozito.com.au...
-
Page 11: Warranty
PURCHASED FROM: ________________________________________________ DATE PURCHASED: ________________________________________________ 3 YEAR REPLACEMENT WARRANTY Your Ozito tool is guaranteed for a period of 36 months from the original date of purchase and is intended for DIY (Do it yourself) use only. WARNING The following actions will result in the warranty being void.
Need help?
Do you have a question about the DDG-560V and is the answer not in the manual?
Questions and answers