Systems; Fresh Water; <Fig. 5 - Bilge D/C Breaker Panel And Fuses - Pro-Line Boats 27 Walk Owner's Manual

13
Circuit Breakers
The wiring on your 27 Walk is protected by circuit breakers and/or fuses. In the event a
device stops working, check to see if the circuit breaker is tripped or the fuse is blown.
The main breaker is located on the bulkhead in the bilge area and is accessible from the
bilge hatch. Additional breakers / fuses for the bilge pumps, trim tabs, etc. are located
next to the main breaker and on the dash panel next to the switches. There are also
additional breaker switches located in the cabin on the A/C – D/C panel. A tripped
breaker will protrude or move from its set position indicating that the circuit has been
overloaded. Turn off the device(s) on the circuit then reset the breaker by pushing in
once or by returning a breaker switch to the "ON" position. If the breaker does not reset
or if it resets and then trips again after the device is turned back on, then a short circuit
exists or your device may be damaged, overloaded, or faulty. Correct the problem and
then reset the breaker. If the breaker continues to trip and you are certain the device,
switch, and wiring is in good repair; then either the breaker is too small for the load or is
faulty. Reduce the load or replace the breaker.
<fig. 5 – Bilge D/C Breaker Panel and Fuses>

Systems

Fresh Water System
The fresh water pump on your Pro-Line supplies water to the transom sink / shower and
to the cabin on demand when a drop in water pressure activates the pressure switch. The
fresh water is activated by the switch on the cabin D/C panel. The switch should be kept
off when not in use or unattended. The fresh water tank and pump are located below the
cabin. The pump is mounted on the port stringer and is accessible by removing the
inspection plate which is installed in the cabin step. The water fill is located on the port
gunwale. The optional water heater is located under the galley area and is accessible by
removing the ice box. Before operating the water heater, make sure all air is purged from
the system by turning on the hot water faucets one at a time until water flows. Failure to
purge the air could result in damage to the heating elements. Top off the fresh water tank