Maintenance; Operating Condition - Sharp AH-PN10 Operation Manual

MAINTENANCE

Be sure to disconnect the power cord from
the wall outlet or turn off the circuit breaker
before performing any maintenance.
CLEANING THE FILTERS
1
Turn off the unit.
2
Remove the filters.
1
Lift the open panel.
2
Pull the air filters down to remove them.
3
Clean the filters.
Use a vacuum cleaner to remove dust. If
the filters are dirty, wash them with warm
water and a mild detergent. Dry filters in the
shade before reinstalling.
4
Reinstall the filters and close
the open panel.
CLEANING THE UNIT AND THE
REMOTE CONTROL
• Wipe them with a soft cloth.
• Do not directly splash or pour water on them.
It can cause electrical shock or equipment
damage.
• Do not use hot water, thinner, abrasive pow-
ders or strong solvents.
OM_AH-PN10 13GY_EN.indd Sec1:11 OM_AH-PN10 13GY_EN.indd Sec1:11
MAINTENANCE AFTER AIR
CONDITIONER SEASON
1
2
3
9,000/12,000 BTU
MAINTENANCE BEFORE AIR
CONDITIONER SEASON
18,000/24,000 BTU
1
2
• The built-in safety device may prevent the unit
• Condensation may form on the air outlet if the
E-11
Operate the unit in the COOL
mode, temperature setting 30˚C,
to thoroughly dry inside the unit.
Stop the operation and unplug the
unit. Turn off the circuit breaker,
if you have one exclusively for
the air conditioner.
Clean the filters, then reinstall
them.
Make sure that the air filters are
not dirty.
Make sure that nothing obstructs
the air inlet or outlet.

OPERATING CONDITION

Mode
Upper limit
Cooling
Lower limit
from operating when used out of this range.
unit operates continuously in the COOL or
DRY mode when humidity is over 80 %.
Indoor Outdoor
Temp. Temp.
32˚C 43˚C
21˚C 21˚C
12/22/11 6:30:22 PM 12/22/11 6:30:22 PM