Summary of Contents for Sharp Eco Inverter AH-XPC9RV
Page 1
SPLIT TYPE ROOM AIR CONDITIONER OPERATION MANUAL INDOOR UNIT AH-XPC9RV AH-XPC12RV Device of this mark is a trademark of Sharp Corporation. Plasmacluster is a registered trademark or a trademark of Sharp Corporation. AH-XPC9RV.indd 11.8.8 1:33:32 PM...
Please read this manual carefully before using the product. This manual should be kept in a safe place for handy reference. • Do not splash or pour water directly on the CONTENTS unit. Water can cause electrical shock or equipment damage. •...
USING THE REMOTE CONTROL AUXILIARY MODE LOADING BATTERIES Use this mode when the remote control is not available. Remove the battery cover. TO TURN ON Insert two batteries. (AAA(R03)) Press the AUX button. Make sure the ( ) and ( ) polarities are cor- rectly aligned.
BASIC OPERATION Press the MODE button to select the operation mode. AUTO COOL Press the ON/OFF button to start operation. • The red OPERATION lamp ( ) will light up. TO TURN OFF Press the ON/OFF button again. • The red OPERATION lamp ( ) will turn off.
ADJUSTING THE AIR FLOW POWERFUL JET OPERATION DIRECTION The air conditioner works at the maximum VERTICAL AIR FLOW DIRECTION power and optimum louvre direction to makes the room cool rapidly. Press the SWING button. • The vertical airflow louvre will swing. During operation, press the POWERFUL JET button.
GENTLE COOL AIR PLASMACLUSTER OPERATION Plasmacluster ions released into the room The vertical airflow louvre is set obliquely upward to deliver cool air to the ceiling in will reduce some airborne mold. order to avoid direct airflow. During operation, press the During operation, press the PLASMACLUSTER button.
SELF CLEAN OPERATION ONE-HOUR OFF TIMER SELF CLEAN operation will reduce the When the ONE-HOUR OFF TIMER is set, the growth mold fungus with Plasmacluster unit will automatically turn off after one hour. ions and dry inside of the unit. Utilize the Press the ONE-HOUR OFF TIMER operation at seasonal change over terms or every 4 months.
TIMER OPERATION TIMER OFF TIMER ON Press the TIMER OFF button Press the TIMER ON button and and set the time as desired. set the time as desired. 0.5h 1.0h 1.5h 0.5h 1.0h 1.5h • The orange TIMER lamp ( ) will light up.
DISPLAY BUTTON OPERATING CONDITION Indoor Outdoor Use when the lamps on the unit are too Mode Temp. Temp. bright. (The red OPERATION lamp and the orange TIMER lamp cannot be turned off.) Upper limit 32˚C 43˚C Cooling Lower limit 21˚C 21˚C During operation, press the DISPLAY button.
MAINTENANCE Be sure to disconnect the power cord from CLEANING THE UNIT AND THE RE- the wall outlet or turn off the circuit breaker MOTE CONTROL before performing any maintenance. • Wipe them with a soft cloth. CLEANING THE FILTERS •...
BEFORE CALLING FOR SERVICE The following conditions do not denote Check the following points before calling for equipment malfunctions service. UNIT DOES NOT OPERATE The unit does not operate The unit will not operate if it is turned on imme- •...