Sharp AH-PN10 Operation Manual page 19

Model 18000/24000 BTU
MOUNTING PLATE
Hook
MOUNTING PLATE
Drain Cap
Insulation
Tape
CONNECTING THE CABLE TO THE INDOOR UNIT
Use a copper cable. (Cross-section area: 2.0 mm
Use a cable which is not lighter than polychloroprene sheathed flexible cord (Code designation 60245 IEC 57).
Use a copper cable. (Cross-section area: 2.0 mm
Connecting cable
Model 9000/12000 BTU
50
40
8
8
OM_AH-PN10 13GY_EN.indd Sec1:17 OM_AH-PN10 13GY_EN.indd Sec1:17
Taping
Drain Hose
Tape
Pipes
Drain Hose
Piping holder
Length unit: mm
Earth wire
E-17
Piping route
For directions 1, 2 , 4 and 5, cut out the specific
zone without leaving any sharp edge.
(Keep the cut-out plate for possible future use.)
Plate
Plate
Exchange the drain hose
(1) Remove the screw and pull out the drain hose.
Screw
(2) Pull out the drain cap.
(3) Reconnect the drain hose to the right and
insert the drain cap to the left.
• Fully insert the drain hose until it stops
and fix the screw removed in (1).
• Insert a hexagon wrench (4 mm diagonal)
into the drain cap, and press it fully.
Screw
Drain Hose
WARNING:
After replacing, make sure that both the drain
hose and drain cap are firmly inserted.
2
) 9,000-12,000-18,000 BTU only
2
) 24,000 BTU only
Model 18000 BTU
90
80
8
8
Earth wire
Plate
Cut the plate along notch.
Plate
Drain Hose
Drain Cap
Hexagon wrench
Drain Cap
Model 24000 BTU
90
80
8
8
Earth wire
12/22/11 6:30:32 PM 12/22/11 6:30:32 PM