Port; Turning On / Off The Power - EverFocus PARAGON960 X4 User Manual

2.3.4 RS-485 Port
The RS-485 port, located on the rear panel of the DVR, can be used to connect to an RS-485
keyboard, such as EverFocus' EKB500, for controlling PTZ cameras. For details on the RS-485
configurations on the DVR, please refer to 6.9.5 I/O Control.
2.3.5 RS-232 Port
The RS-232 port, located on the rear panel of the DVR, can be used to connect to an RS-232 data
input device such as POS system. The RS-232 port of the PARAGON960 X4 is a 9 pin D-Sub socket.
For details on the RS-232 configurations on the DVR, please refer to 6.9.5 I/O Control.
2.4

Turning On / Off the Power

Before powering on the DVR, please make sure the internal HDDs have been installed properly.
Once you have completed the basic cable connections, you are ready to turn on the DVR.
Simply connect the supplied Power Cord to the power outlet. All of the LED indicators on the front
panel will light up. The DVR will automatically run an internal process, when the process is
complete, the LED indicators will turn off, and the POWER LED will remain light up in green. And
then you can start operating the DVR. To turn off the power, simply unplug the Power Cord from
the power outlet.
Rear View
RS-485 Port
EKB500
RJ-45 Cable
Connector Box
Figure 2-17
PARAGON960 X4
Figure 2-18
17
RS-485
PTZ Camera 1~16
PARAGON960 X4