EverFocus PARAGON960 X4 User Manual page 109

Schedule setting using Mouse
1. Select a camera first and click on desired start time block (no number on it) on a time bar.
At this time, the selected time block will be highlighted in yellow frame and the entire
time bar will be highlighted by red frame.
2. Click the desired start time block again to confirm, and this block (shows a new sequence
number on it) and all the following blocks will turn to gray. This means the grey time
blocks has been set to No Recording mode.
3. To change the time blocks to different record mode (which shows a different color),
users need to click again on the block (with number on it) of any section. Every time the
user clicks the first block of a section, the color switches from gray->pink ->blue-green.
4. Repeat the above steps to configure the record modes. You can configure up to six
record modes on each time bar.
Schedule setting using the front panel buttons
1. Enter schedule setting mode: Select the "Schedule' icon on the configuration menu and
press the 'Enter' button; the left hand column will be highlighted in a white frame. Use
the Jog wheel to highlight the 'Schedule' choice and press the "Enter" button to enter the
schedule setting mode. At this time, the whole editing area at the lower right side will be
highlighted within a white frame.
2. Selecting camera: Use the Shuttle/Jog wheel to switch to Camera selection mode. The
selected camera number will be highlighted with a green frame, and press Enter button.
Figure 6-35
Figure 6-36
101
PARAGON960 X4