Table of Contents
Advertisement
This chapter provides bar codes for programming the Socket S 2208
scanner for the following optional user preferences:
•
Beeper tone
•
Beeper volume
•
Variable length scan line
•
Laser on time
Your scanner is shipped with the settings shown below (also see
Appendix C, "Default Parameters," for a complete list with all
parameters). If the default values suit your requirements, programming
may not be needed.
Table 6-1. Default User Preferences
Parameter (User Preference)
Set Default Parameters
Beeper Tone
Beeper Volume
Variable Length Scan Line
Laser On Time
IMPORTANT!
The S-2208 is pre-programmed to operate only with the Socket Bar
Code Laser Scanning Card and cable. Changing any host or
communication protocol parameters will cause the scanner to be
inoperative.
To prevent accidental modifications to the S-2208 default parameters,
all host and communication programming bar codes have been removed
from both this User's Guide and the S-2208 Advanced Programming
Guide available on Socket's website.
CHAPTER 6: USER PREFERENCES
6 | User Preferences
Default
All Defaults
Medium
High
Full Length
3.0 Sec
33
Advertisement
Table of Contents
