Alto LYNX-MIX USB SERIES User Manual page 17

45 PHONES Jacks
These jacks will be used to send the signal to a pair
of headphone or to powered studio monitors.
46 LAMP socket
This lovable LAMP is very convenient for your operation,
it is located in the top right corner of the front panel,
and provides the 12V socket that can drive standard
BNC-type lamp.
REAR PANEL
47 48
POWER PHANTOM
ON
OFF
Apparaten skall anslutas
till jordat uttag nar den
ansluts till ett natverk
AC INPUT
100-240V 50/60Hz
Fuse: T1AL
RATED POWER CONSUMPTION: 65W
49
47 POWER Switch
This switch is used to turn the main power on and off.
48 +48 Volt Phantom Power
It is available only to the XLR MIC sockets. Never plug in a microphone when
phantom power is already on. Before turning phantom power on, make sure
that all faders are totally down. In this way, you will protect your stage
monitors and main loudspeakers.
49 AC Inlet with FUSE Holder
Use it to connect your L YNX-MIX USB mixer to the main AC with the
supplied AC cord. Please check the voltage available in your country and how
the voltage for your L YNX-MIX USB mixer is configured before attempting
to connect your L YNX-MIX USB mixer to the main AC.
3. CONTROL ELEMENTS 4. CONTROL ELEMENTS
51 52
54
53
MAIN MIX OUTPUT (BAL/UNBAL)
USB
+4dBu
-30dBu
SUB MAIN
1/2 MIX. 15/16
L
MAIN
RECORD
OUTPUT
LEVEL
MAIN INSERT MONO CTRL OUT
0
L L - +15 L
R R R R
TIP SEND
(BAL/UNBAL)
RING RETURN
56
50 55
57
61
59
AUX SENDS
1 2 3 4
CH MAIN
MIX.
PLAY BACK
DFX OUT AUX RETURNS
1 2 3 4
L L L L
R R R R
FOOT SWITCH
58
60
62
46
45
63
DIRECT OUTS (BAL/UNBAL)
CH8 CH7 CH6 CH5 CH4
SUBGROUPS OUT
1 2 3 4
1 2 3 4
SUBGROUPS INSERT
65
64
CH3 CH2 CH1
15