Table of Contents
Advertisement
10 MID
This is a peaking filter and it will boost/cut frequencies from 100 Hz to 8 kHz
depending on the position of the MID freq control. This control will affect
especially upper male and lower female vocal ranges and also the harmonics
of most musical instruments.
11 HI-MID
This control gives you up to 15 dB boost
or cut at 3 kHz. It is useful for controlling
voice. It can accurately polish your
performance via adjusting this knob.
12 MID-LOW
This control gives you up to 15 dB boost
or cut at 500 Hz.
13 LOW
If you turn this control up, you will boost
all frequencies below 80 Hz. You will give
more punch to bass drum and bass guitar
and make the vocalist more "macho". Turn
it down, you will cut all the frequencies
below 80 Hz. In this way, you can avoid low-
frequency vibrations and resonance thus
preserving the life of your woofers.
14 AUX SENDS Level Control
These four controls are used to adjust the
level of the respective signal sent to AUX
bus, AUX1 and AUX2 can be switched to
PRE/POST-FADER via the PRE/POST button,
so, generally, they can be used for monitor
application and effects & sound processors input. AUX3 and AUX4 are
configured as POST-Faders. In this typical compact unit, excluding sending
out the signal directly to the external effect or processor equipment, AUX
SEND4 can also be assigned to the internal onboard effect module.
15 PAN/BAL Control
Abbreviation of PANORAMA control for mono channels, or the stereo channels,
always says, BALANCE control. Keep this control in center position, then the
signal will be positioned in the middle of stage.
4. CONTROL ELEMENTS
9
10
13
14
15
16
19
11
12
17
18
9
Advertisement
Table of Contents
