Alto LYNX-MIX USB SERIES User Manual page 19

3. CONTROL ELEMENTS
59 DFX OUT Jack
This 1/4" phone jack is used to output the effect signal that comes from
internal DSP module and the signal level can be controlled by the EFFECTS
OUT(40) control.
60 FOOTSWITCH Jack
This 1/4" phone jack can be used to connect an external footswitch to turn on/
off the onboard effect module.
61 AUX SENDS Jacks
These 1/4" phone jacks are used to send out the signal from the AUX Bus to
external devices such as effect units and/or stage monitors.
62 AUX RETURNS Jacks
Use these stereo 1/4" phone jacks to return the stereo signal of an effect unit
to the Main Mix. Alternatively you can also use them as an extra auxiliary input
via using the AUX RETURN level control as volume control. The signal will be
sent directly to MAIN MIX control.
63 DIRECT OUTS
Each Mono MIC/LINE Channel (CH1-CH4 for L YNX-MIX124 USB, CH1-CH8 for
L YNX-MIX164 USB, CH1-12 for L YNX-MIX204 USB) is equipped with the 1/4"
phone jack for directing output. These jacks are used to send the signal from
the channel path to external device for recording function etc..
64 SUBGROUPS OUT Jacks
These 1/4" phone jacks are used to connect the inputs of deck or secondary in
a complicated PA live sound system. You will find it is the best tool when you
operate the SUBGROUPS OUT.
65 SUBGROUPS INSERT
These 1/4" phone jacks are insert points. They are used to connect processors,
such as compressor, limiter, EQ etc.. When insert external processor into
these jacks, the subgroup stereo signal will be taken out, then returned to
before subgroups fader. Of course, these
Ring Return).
4. CONTROL ELEMENTS
used jacks must be stereo (Tip Send/
17