Alto LYNX-MIX USB SERIES User Manual page 10

instrument, you shall read the LINE ring
(+15~-35 dB for mono MIC input,
-
+20~ 20 dB for stereo channels). For
optimum operation, you shall set this
control in a way that the PEAK LED(16)
blinks only occasionally in order to avoid
distortion on the input channel.
5 LINE GAIN
When you use a line level instrument, you
shall read the ring (-20~+20 dB). For
optimum operation, you shall set this
control in a way that the PEAK LED (16)
blinks only occasionally in order to avoid
distortion on the input channel.
6 LEVEL SET LED
This LED will help you to detect the input level immediately. In this case, the
research of the fault will become much faster!
7 LOW-CUT Button
By pressing this button, you will activate a 75 Hz low frequency filter with a
slope of 18 dB per octave. You can use this facility to reduce the hum noise
infected by the mains power supply, or the stage rumble while using a
microphone.
8 LINE/USB Button
By pressing this button, it will switch to the USB mode, then the USB signal
can be sent to this channel or the Main Mix channel; by releasing this button,
the LINE IN inputs signal will send to the line input channels.
EQUALISER
There are 3-band EQ with sweepable MID on all mono input channel1-4 (1-8 for
L YNX-MIX164 USB, 1-12 for L YNX-MIX204 USB): HI, MID and LOW band. There
are 4-band fixed frequency EQ on the stereo channel 5-12 (9-16 for L YNX-MIX164
USB, 13-20 for L YNX-MIX204 USB): HI, HI-MID, MID-LOW and LOW band. All bands
provide up to 15 dB of boost or cut.
9 HI
If you turn this control up, you will boost all the frequencies above 12 kHz (shelving
filter). You will add transparency to vocals and guitar and also make cymbals crispier.
Turn the control down to cut all frequencies above 12 kHz. In such way, you can
reduce sibilances of human voice or reduce the hiss of a Tape player.
8
4. CONTROL ELEMENTS
5
4
6
7
6
8