Alto LYNX-MIX USB SERIES User Manual page 16

39 DSP MUTE Switch & PEAK LED
This switch is used to activate/deactivate the effect facility. This LED lights up
when the input signal is too strong. In case of the digital effect module being
muted, this LED also lights up.
40 EFFECTS OUT Control
Rotate this knob to adjust the level of effect signal that intercepted from
internal DSP processor and directly sent to DFX OUT, which can be varied
from - to +15 dB.
41 DFX2 (INT) RETURN EFFECTS TO MONITOR
The AUX1 and AUX2 controls are used to set the signal level from AUX
RETURN4, which signal will be sent to AUX SEND1 and AUX SEND2. The
adjustable range can be varied from -
42 POWER LED
The LED indicates when the power is ON.
43 PHANTOM LED
This LED indicates when the phantom power is switched on.
44 2-TRACK IN/OUT
-TAPE IN
Use the Tape input if you wish to listen to your mix
from a Tape Recorder or DAT.
- TAPE OUT
These RCA jacks will route the main mix into a tape
recorder.
14
3. CONTROL ELEMENTS
4. CONTROL ELEMENTS
40 41 37 38
to +15 dB.
42
43
39
44