Alto LYNX-MIX USB SERIES User Manual page 13

22 Master AUX SENDS Controls
These four controls are used to
determine the master AUX SEND
levels, which can be varied from -
to +15 dB. When the external effect
units which has no input gain control
were connected to mixer, you can get
a further +15 dB gain available from
these Aux Send outputs. As to the
AUX4, it can also provide the lovable
level adjustment for the internal
effect signal.
23 SOLO Button
The function of these SOLO buttons
are the same as the channel SOLO
button, they can also be affected by
the SOLO MODE switch. Press the
Solo button, the corresponding AUX
send will be routed to the Ctrl Room/
Phones outputs and Meters display.
24 Master STEREO AUX RETURNS Controls
These four controls set the level of effects that received from the stereo AUX
RETURN connectors, which can be varied from -
provide the further gain for low level effects.
25 TO AUX SEND1/2
The both rotary knobs assign the AUX RETURN signals to their respective
AUX SEND outputs: The "TO AUX SEND1" assign the signal from AUX
RETURN1 to AUX SEND1 bus, and "TO AUX SEND2" assign the signal from
AUX RETURN2 to AUX SEND2 bus. The adjustable range goes from -
+15 dB.
26 MAIN MIX & CTRL/R Button
AUX RETURN3 is equipped with the Main Mix & Ctrl/R button. Release the
button to send the stereo signal from AUX RETURN3 to MAIN MIX buses;
Engage the button, then the stereo signal will be sent to CTRL/R output.
4. CONTROL ELEMENTS
23 24
22
27
29
30
to +15 dB. They are used to
25 20 21
26
33
28
32
34
31
to
11