5-2
Using CD/DVD
Manually Ejecting a Disc
If you choose to eject a disc when the power is off, complete the following
steps to manually eject the disc.
1. Make sure the power is off and any external power sources are
disconnected.
2. Insert a metal rod (approximately 1/16 inch in diameter and at least
3/8 inch in length) into the manual eject hole and push firmly as shown.
You may use a straightened paper clip.
3. After the CD/DVD tray pops open, gently pull it out from the drive until
it is fully extended, then remove the disc.
4. If the tray does not open, contact your local Compaq authorized dealer,
reseller, or service provider.
Manually Ejecting a Disc