Table of Contents
Advertisement
The grant of a Telepermit for any item of terminal equipment indicates only
that Telecom has accepted that the item complies with minimum conditions for
connection to its network. It indicates no endorsement of the product by
Telecom, nor does it provide any sort of warranty. Above all, it provides no
assurance that any item will work correctly in all respects with another item of
Telepermitted equipment of a different make or model, nor does it imply that
any product is compatible with all of Telecom's network services.
This equipment is not capable, under all operating conditions, of correct
operation at the higher speeds for which it is designed. Telecom will accept no
responsibility should difficulties arise in such circumstances.
This device is equipped with pulse dialling while the Telecom standard is
DTMF tone dialling. There is no guarantee that Telecom lines will always
continue to support pulse dialling.
Use of pulse dialling, when this equipment is connected to the same line as
other equipment, may give rise to bell tinkle or noise and may also cause a false
answer condition. Should such problems occur, the user should not contact the
Telecom Faults Service.
Some parameters required for compliance with Telecom's Telepermit
requirements are dependent on the equipment (PC) associated with this device.
The associated equipment shall be set to operate within the following limits for
compliance with Telecom's Specifications:
1. There shall be no more than 10 call attempts to the same number within
any 30 minute period for any single manual call initiation, and
2. The equipment shall go on-hook for a period of not less than 30 seconds
between the end of one attempt and the beginning of the next attempt.
This equipment should not be used under any circumstances which may
constitute a nuisance to other Telecom customers.
This equipment shall not be set to make automatic calls to the Telecom '111'
Emergency Service.
11-27
User's Guide
Advertisement
Table of Contents
