Related Manuals for Standard Horizon HX407
Summary of Contents for Standard Horizon HX407
- Page 1 Application for FCC / IC FCC ID: K6630394X20 IC: 511B-30394X20 HX407 UHF FM Marine Transceiver Owner’s Manual...
- Page 2 50%, in typical Push-to-Talk configurations. DO NOT transmit for more than 50% of total radio use time (50% duty cycle). Transmitting more than 50% of the time can cause FCC RF expo- sure compliance requirements to be exceeded. Page 2 HX407...
- Page 3 The CLIP-22 belt-clip must be used in order to comply with the FCC/IC RF exposure requirements. Always use Standard Horizon authorized accessories. The information listed above provides the user with the information need- ed to make him or her aware of RF exposure, and what to do to assure that this radio operates with the FCC RF exposure limits of this radio.
-
Page 4: General Information
The HX407 is a JIS-8 / IPX8 (1.5 m (about 5Ft) for 30 minutes) Submersible 2-Watt portable two way marine transceiver with the capability to be pro- grammed with CTCSS or DCS signalling by a dealer. -
Page 5: Packing List
230 VAC (Type-C plug), and “U” suffix is for use with 230 VAC (Type-BF plug). Note: Before operating the HX407 for the first time, it is recommended that the battery be charged. Please see section “3.3.3 BATTERY CHARGING” for details. -
Page 6: Getting Started
The design of the HX407 allows water to enter between the radio and the battery pack, however waterproof performance is not compromised. After using the HX407 in salt water environment is recommended to clean the radio with fresh water by rinsing the battery and radio (separately) under a sink facet or by dunking in a fresh water. -
Page 7: Batteries And Chargers
Battery packs should be charged only in non-hazardous environments; Use only STANDARD HORIZON-approved batteries; Use only a STANDARD HORIZON approved charger. The use of any other charger may cause permanent damage to the battery. Follow charging instructions provided with the chargers. -
Page 8: Battery Installation And Removal
To remove the battery, turn the radio off. Slide the Battery Pack Latch on the bottom of the radio, then lift up on the bottom of the battery and re- move it from the radio. HAND STRAP INSTALLATION Page 8 HX407... -
Page 9: Battery Charging
NOTE The CD-50 cradle is only designed for the charging of the HX407’s bat- tery, and is not suitable for other purposes. The CD-50 may contribute noise to TV and radio reception in the immediate vicinity, so we do not recommend its use adjacent to such device. -
Page 10: Controls And Switches
Earpiece/Microphone. When this jack is used, the internal speaker and microphone are disabled. 1) Do not allow the HX407 to become submerged in water HX407 while the plastic cover over the MIC/SP jack is removed. P-CH 2) Do not remove/install the ... - Page 11 Keypad [P-CH], [MON], [P1] - [P4] Key The Programmable key functions can be customized,via programming by your STANDARD HORIZON dealer, to meet your communications/ network requirements. Press the key momentarily to increase the channel one step. Hold the key down to increase the channel continuously.
-
Page 12: Lcd Indicators
” icon is shown on the LCD, all keys are disabled except for the PTT ( ) key. ⑪ “ ” Indicators This indicator shows when the TX output power is selected to “Low” (1 Watt) power. Page 12 HX407... - Page 13 Application for FCC / IC FCC ID: K6630394X20 IC: 511B-30394X20 MEMO HX407 Page 13...
-
Page 14: Basic Operation
) switch is held down, transmission time is limited to 5 minutes. This prevents prolonged (unintentional) transmissions. About 10 seconds before automatic transmitter shutdown, a warning beep will sound from the speaker. The transceiver automatically switches to the receiving Page 14 HX407... - Page 15 PTT ( ) switch. NOTE The PTT ( ) switch is disabled for 10 seconds after the transceiver au- tomatically switches to the receiving mode by the TOT feature. HX407 Page 15...
-
Page 16: Advanced Operation
Press and hold the assigned programmable key causes the radio to begin stepping (repeatedly) upward or downward through the channels. Key Lock In order to prevent accidental channel change, the HX407’s keypad may be locked. Lamp Press (or press and hold) the assigned Programmable key to illuminate the display for five seconds. - Page 17 Talk Around Press (or press and hold) the assigned Programmable key to activate the Talk Around feature. Direct Ch1 - 4 Press (or press and hold) the assigned Programmable key to recall the Deal- er pre-programmed channel directly. HX407 Page 17...
-
Page 18: Menu ( "Set" ) Mode
FCC ID: K6630394X20 IC: 511B-30394X20 7. MENU ( “SET” ) MODE The Setup Menu allows a number of the HX407 operating parameters to be custom-configured for your operating requirements. The Menu Mode is easy to activate and set, using the following procedure: 1. -
Page 19: Scan Memory
Function: Select the VOX gain. Available Values: 1 / 2 / 3 / 4 / 5 (level) VOX TIMER Function: Select the VOX delay time. Available Values: 1 / 2 / 3 / 4 / 5 (sec) HX407 Page 19... -
Page 20: Maintenance
IC: 511B-30394X20 8. MAINTENANCE 8.1 GENERAL The inherent quality of the solid-state components in STANDARD HORIZON radios will provide many years of continuous use. Take the following precau- tions to prevent damage to the radio. To prevent corrosion of electrical contacts and keep the water resis- ... -
Page 21: Warranty
United States, contact the dealer in your country. STANDARD HORIZON (a division of YAESU U.S.A.) warrants, to the original purchaser only, each new Marine Communications Product (“Product”) man- ufactured and/or supplied by STANDARD HORIZON against defects in ma-... - Page 22 This warranty only extends to Products sold within the 50 States of the Unit- ed States of America and the District of Columbia. STANDARD HORIZON will pay all labor to repair the product and replace- ment parts charges incurred in providing the warranty service except where purchaser abuse or other qualifying exceptions exist.
-
Page 23: On-Line Warranty Registration
Product Support Inquiries If you have any questions or comments regarding the use of the HX407, you can visit the STANDARD HORIZON Web site to send an E-Mail or contact the Product Support team at (800) 767-2450 M-F 8:00AM to 5:00PM PST. -
Page 24: Installation Of Option
FBA-42 is a battery tray that holds six AA size Alkaline batteries and is used with the HX407 transceiver. When the FBA-42 is installed into the HX407 the radio can withstand immersion in water up to 1.5 m (about 5Ft) for 30 min- utes. -
Page 25: Specifications
Max imum Audio Output Power: 700 mW @16 for 10 % THD (@7.4 V) AF Output (External SP): 300 mW @8 for 10 % THD (@7.4 V) Spurious Emission: Less than 2 nW Measured in accordance with TIA/EIA-603. HX407 Page 25... -
Page 26: Fcc And Canada Radio License Information
Application for FCC / IC FCC ID: K6630394X20 IC: 511B-30394X20 FCC AND CANADA RADIO LICENSE INFORMATION Standard Horizon radios comply with the Federal Communication Commis- sion (FCC) and Industry-Canada requirements that regulate the Maritime Radio Service. MARITIME STATION LICENSE An FCC ship station license is no longer required for any vessel traveling in U.S. - Page 27 Les types d’antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l’exploitation de l’émetteur. l’établissement d’une communication satisfaisante. HX407 Page 27...
- Page 28 Application for FCC / IC FCC ID: K6630394X20 IC: 511B-30394X20 Copyright 2015 YAESU MUSEN CO., LTD. All rights reserved. No portion of this manual may be reproduced without the permission of YAESU MUSEN CO., LTD. YAESU USA 6125 Phyllis Drive, Cypress, CA 90630 Printed in Japan...
Need help?
Do you have a question about the HX407 and is the answer not in the manual?
Questions and answers