Operation; Priority Scan - Standard Horizon HX100 Owner's Manual

Memory Scan: Scans the Scan Memory and channels
6. After completing your selection, turn the transceiver off and on by press-
ing and holding the
P
riority

6.9.3 OPERATION

The operation of the "Priority Scan" or "Memory Scan" is determined via the
section "6.9.2 SELECTING THE SCAN TYPE"

6.9.3.1 Priority Scan

1. Press the
then press the
2. Press the
blinking "P" and "M" icons will appear on the display
during scanning.
3. When the HX100/HX150 receives a transmission on a
working channel, it will stop on the working channel and
"Dual Watch" (described in next chapter) the priority
channel until the incoming signal disappears, then start
scanning again.
4. When the HX100/HX150 receives a signal on the Prior-
ity channel it will stay on this channel until the incoming
signal disappears, then start Priority scanning again.
5. To stop the scanning, press the
Page 28
programmed into the Preset Channel
memory.
key.
S
can
key twice to activate the squelch level adjustment mode,
/ key until the background noise disappears.
key to start scanning, a "SCN" icon and
M
eMory
key.
S
can
HX100/HX150