Adjusting The Table Insert - SawStop CB31230 Owner's Manual

Making Adjustments to Your Saw
The head of the bolt is painted yellow for easy
identification. To adjust the position of the 45° limit
bolt, first loosen the locking nut and back it off
several turns. Next, turn the 45° limit bolt clockwise
to increase the angle of the limit stop, or counter-
clockwise to decrease the angle of the limit stop.
Now turn the tilt hand wheel clockwise until the
limit stop is reached. Recheck the angle of the
blade relative to the table. If further adjustment is
needed, decrease the tilt angle to about 30° and
readjust the 45° limit bolt. Repeat this process until
the blade is at 45° to the table when the limit stop
is engaged.
Once the 45° limit bolt is properly adjusted, turn
the locking nut clockwise until it is tight. The 45°
limit stop has now been set.
45° tilt
limit stop
Fig. 63

6. Adjusting the Table Insert:

The SawStop zero clearance insert has been designed to fit securely within the table opening and just below
the table top. The insert is pre-cut at the factory with a 10 inch blade after all alignments to the saw have been
completed.
As shown in Fig. 64, the insert includes front
and rear leveling screws to set the height
rear leveling
of the insert. In addition, positioning screws
screws
at the front and right side of the insert
prevent it from rattling in the table opening.
Finally, a lock-down screw at the front of
the insert prevents the insert from rising
up unexpectedly. The lock-down screw fits
inside an adjustable threaded bushing that front leveling
screws
prevents the lock-down screw from pulling
the front of the insert too low.
To set the height of the insert, first remove
the lock-down screw. Next, back off the
threaded bushing by turning it counter-
clockwise about one full turn using the
included 5 mm hex wrench. Then use the
included 3 mm hex wrench to adjust the
front and rear leveling screws until the insert
positioning
is just below the surface of the table. The
screws
front lockdown
lower end of each leveling screw should rest
screw
on the corresponding support ledge on the
Fig. 64
table.
SawStop 10" Professional Cabinet Saw 61